AMICUS GREEN BUILDING CENTER
  • Home
  • Contact/Find Us
  • Store & Virtual Showroom
  • Project Services
  • Project Portfolio
  • About Us
  • Testimonials
  • In the Media
  • Amicus Briefs: Our Blog
  • Terms of Use & Policies
  • Welcome to the Sustainable Living Exhibit
  • Store & Virtual Showroom
  • >
  • Paints & Finishes
  • >
  • Offgassing Sealers
  • >
  • AFM Safecoat Hard Seal

AFM Safecoat Hard Seal

SKU:
$25.88
25.88 358.88 $25.88 - $358.88
Unavailable
per item

Safecoat Hard Seal is a multi-use, clear gloss sealer especially formulated to provide mar resistance to both low and high porosity surfaces. Because it forms a continuous membrane when applied properly it is particularly effective at sealing in any pollution or toxic chemical compounds outgassing from the surface to which it is applied.


Use on: Typically used on previously uncoated and unsealed woodwork, cabinetry and vinyl tile. To prevent outgassing of previously coated surfaces, can also be applied over existing paints, stain and colorfast wallpaper. When applying to a previously coated surface test in inconspicuous places for satisfactory appearance. Not for use on particle board or chipboard.


Coverage: One gallon of Safecoat Hard Seal covers approximately 350 square feet in one coat depending on surface porosity. One quart covers approximately 85 square feet.

  • Facebook
  • Twitter
  • Pinterest
  • Google+
Add to Cart
Application: Always have adequate ventilation. Before using, mix coating thoroughly by gently stirring or rolling container to avoid air bubbles. Be sure to stir product thoroughly every 20 minutes during application. Do not shake container. Pour material to be used into another container before applying coating to avoid contaminating main container. Then apply as is, using a quality nylon brush, pad applicator, or unheated spray applicator. Apply liberal coats, keeping a good wet edge and avoid overbrushing.

In most cases, a minimum of 2 coats is required, depending on the surface.

When spraying, use a .015 tip or smaller. Apply thin even coats when spraying rather than heavy coats which will tend to sag. If spray pattern begins to dryspray, reduce air pressure and increase material flow to surface. Use a damp, dust free rag after sanding to remove dust particles. Use aluminum oxide or silicon carbide sandpaper to sand between coats.

Use only during low or moderate humidity conditions. Applying this product over lightly dampened surfaces can assist the user in controlling the dry time. Smoother finishes are achieved when surfaces are damp during application.

For best results, this product should not be reduced. Note these instructions are intended to be general only and not exhaustive. The applicator should determine what preparation and techniques are best suited to the specific surface. Refer to product label for full instructions.

Store & Services

Online Store & Virtual Showroom
Project Portfolio
Project Services

Company

About
Contact/Find Us
Testimonials
In the Media

Support

Terms of Use & Policies
Accept Credit Cards
© COPYRIGHT 2015-2019. ALL RIGHTS RESERVED.
  • Home
  • Contact/Find Us
  • Store & Virtual Showroom
  • Project Services
  • Project Portfolio
  • About Us
  • Testimonials
  • In the Media
  • Amicus Briefs: Our Blog
  • Terms of Use & Policies
  • Welcome to the Sustainable Living Exhibit