AMICUS GREEN BUILDING CENTER
  • Home
  • Contact/Find Us
  • Store & Virtual Showroom
  • Project Services
  • Project Portfolio
  • About Us
  • Testimonials
  • In the Media
  • Amicus Briefs: Our Blog
  • Terms of Use & Policies
  • Welcome to the Sustainable Living Exhibit
  • Store & Virtual Showroom
  • >
  • Paints & Finishes
  • >
  • Concrete, Stone & Tile Stains & Sealers
  • >
  • AFM Safecoat MexeSeal

AFM Safecoat MexeSeal

SKU:
$74.88
$74.88
Unavailable
per item
Safecoat MexeSeal is a very low VOC, low odor, water-based, clear sealer for use on interior surfaces where a durable finish and superior protection are needed. It is slip and scuff resistant.

Use on:
recommended on substrates such as unpolished marble, limestone, granite, sandstone, slate, fireclay (brick, tile, terra cotta, pavers), concrete (brick, tile, precast panels, cast in place). MexeSeal is generally not suited for polished surfaces. Not recommended for use on modern Saltillo or quarry tiles without special care. Saltillo or quarry tiles generally contain salts and other contaminants sensitive to application of water based products. White efflorescence flushing may occur. It may be necessary to repeatedly remove contamination and repeat MexeSeal application until all contaminants are extracted.

It is suitable for recoating many water-based sealers and for use on porous interior tile or masonry surfaces where oil and water repellency are desired. Ideal for long term protection against food, oil and water stains on residential or commercial floors.

Nonhazardous and non-flammable, it has been safely used by and for the chemically sensitive

SCS Indoor Advantage Gold Certified

Coverage:
Approximately 300 square feet per gallon in one coat depending on surface porosity.

  • Facebook
  • Twitter
  • Pinterest
  • Google+
Add to Cart
Application: Always test in small, inconspicuous places before full application. To assist in quick drying/curing, bring adequate ventilation and air flow to the work area. Before using, stir Mexeseal thoroughly but without excessive agitation so as to avoid air bubbles. Then apply as is, using a squeegee brush, roller, sponge or appropriate spray equipment. Apply in thin coats. Allow at least two hours to dry between coats. For best results, this product should not be reduced. Two or more coats may be needed depending on porosity of masonry product. Apply only to a completely dry substrate. Correct application will often slightly deepen color of existing surface.

Note: these instructions are intended to be general only and not exhaustive. The applicator should determine which preparation and techniques are best suited to the specific surface. Refer to product label for full instructions.

Store & Services

Online Store & Virtual Showroom
Project Portfolio
Project Services

Company

About
Contact/Find Us
Testimonials
In the Media

Support

Terms of Use & Policies
Accept Credit Cards
© COPYRIGHT 2015-2019. ALL RIGHTS RESERVED.
  • Home
  • Contact/Find Us
  • Store & Virtual Showroom
  • Project Services
  • Project Portfolio
  • About Us
  • Testimonials
  • In the Media
  • Amicus Briefs: Our Blog
  • Terms of Use & Policies
  • Welcome to the Sustainable Living Exhibit