OSMO Floor Brush
This floor brush is 220 mm wide (8.66"), made especially for applying Original Polyx-Oil and all Wood Wax Finishes. It's a convenient and effective way to get great results.
Thread a standard extension pole into the metal base.
DIRECTIONS FOR USE
- Stir the Osmo Polyx-Oil finish well and pour into a tray.
- Take the Osmo Floor Brush and dip approximately 1cm into product.
- Brush the Osmo Polyx-Oil very thinly and evenly onto the wood floor following the grain in a back-and-forth scrubbing motion.
- Take care to avoid brush-stops, excessive areas of product
- Store the brush in a plastic bag overnight to prevent drying
- Clean with Osmo Brush Cleaner and Thinner
TIPS
The Floor Brush should only be saturated lightly. Please be aware that Osmo Polyx®-Oils have a high yield (see product label). Product excesses and brush marks must be blended and smoothed out immediately.
After finishing work, the Floor Brush can be wrapped in plastic wrap and kept airtight until required for the 2nd coat the next day.
OSMO Polyx Oil (High Solid)
High-solids version ("The Original Hardwax Oil")
Osmo Polyx-Oils are hardwearing and extremely durable. For interior use only.
Preserves the look and feel of natural wood.
Economical: 2.5 liters covers approx. 300 sq. ft over 2 coats
Benzene-free solvent — leaves nothing toxic behind when dry.
The surface becomes water-repellent, dirt-resistant and resistant to wine, beer, cola, coffee, tea, fruit juices, milk and water, according to DIN 68861-1A (German Industry Standard)
Repairable: you can buff out scratches and feather in new finish. No need to strip and refinish the entire floor/surface. Also, use the Maintenance Kit, Liquid Wax Cleaner, and Wash & Care for easy upkeep and repair.
Microporous: while it is water repellent, the finish allows the floor to breathe. This is very useful for using in wetter places like kitchens.
Apply with the OSMO Floor Brush or by buffer. Check out the videos below.
Matte (#3055) is very low sheen, almost "dead" finish.
Satin/Matte (#3054) is the original sheen Polyx Oil. A low/medium level sheen level.
Gloss (#3011) adds more gloss sheen to the finish. It is not high-gloss, more of a semi-gloss level sheen.
Natural (#3041) is specifically geared to light-colored low-extractive wooden flooring – for a finish without the permanent wet look! Transparent, matte finish with the goal of creating a neutral effect to minimize color change. However, please note, the desired results of the color tone may vary depending on the wood species.
OSMO Pro 5125 Polyx Oil (Full Solid)
Excellent coverage: 1 liter covers 700 square feet per coat
Fast application with bladed trowel and low speed buffer
Protects wood from the elements while allowing for a natural wood grain feel.
Highly recommended for solid wood and plankwood flooring, blockstrip, OSB and cork floors
Enhances the tone of the wood, repels water and dirt, is resistant to abrasion and extremely hard-wearing.
Healthy: solvent-free and under 50 g/l VOC
Low odor
LEED compliant
Microporous: allows wood to breathe; useful for kitchens, baths and other areas prone to wetness.
Repairable: For renovation, normally 1 coat applied to a clean and dry surface is sufficient – no sanding necessary! Scratches can be buffed out.
For clear: Apply two very light coats
For colors: Apply one coat of OSMO Pro Color Oil and one coat of Pro Polyx Hardwax Oil.
Winner of Green Building Product Dealer 2009 award for best natural wood finish